Selecting a VT Module to Configure

1. In the VT Setup software go to the Unit Select tab and connect to a site.
2. Go to the Logger Setup tab and choose the controlling Logger from the Unit Address list.
3. Select the VT setup tab. More tabs appear.
4. Identify the VT unit that you wish to set-up, and choose its address in the Select VT tab.
5. Check you have the correct VT module by clicking the Flash Up/Down on this VT button. The module's count lights will flash three times.
6. If you are working with a VT module that is not the first in the list then the software needs to read its settings. You can do this in two ways: either click the Tune button, or move to the Settings tab and click button 1 Read settings from module. This might take a few moments. When you do this your VT module stops counting and its count lights flash.
7. You are now ready to configure your module.